Vacuum epoxy resin cast transformers are widely used due to their various advantages, including low noise, low partial discharge, high reliability, and long service life. To ensure the safe and stable operation of these transformers, several tests need to be conducted before putting them into operation.

(1) Insulation resistance test:

This test is performed to ensure the proper insulation resistance of the transformer windings. A megger is used to measure the insulation resistance between the winding and ground. The recommended value for insulation resistance is 1 megaohm or higher.

(2) Ratio test:

The ratio test is conducted to verify the turns ratio of the transformer. The actual turns ratio is measured and compared with the design specification.

(3) Polarity test:

The polarity test is performed to determine the polarity of the transformer windings. This test is essential to ensure that the transformer windings are correctly connected.

(4) Winding resistance test:

The winding resistance test is performed to determine the resistance of the transformer windings. This test is used to check the correctness of the transformer design and to identify any faulty winding.

(5) No-load loss and excitation current test:

The no-load loss and excitation current test is conducted to determine the no-load loss and excitation current of the transformer. These values are important for calculating the efficiency of the transformer.

(6) Load loss and impedance voltage test:

The load loss and impedance voltage test is conducted to determine the load loss and impedance voltage of the transformer. These values are essential for calculating the regulation and efficiency of the transformer.

(7) Insulation level test:

The insulation level test is conducted to determine the insulation strength of the transformer. This test is essential to ensure the transformer’s ability to withstand the specified voltage without any insulation failure.

In conclusion, these tests are essential to ensure the safe and reliable operation of vacuum epoxy resin cast transformers. Properly conducted tests can detect any faults or defects in the transformer, enabling corrective measures to be taken before putting the transformer into operation.

Additionally, before commissioning, the vacuum epoxy casting transformer should undergo insulation resistance tests, oil pressure tests, and dielectric strength tests to ensure that it meets the safety and performance standards. These tests help to identify any potential issues and ensure that the transformer is functioning correctly before being put into operation.

Contact

LuShan, heure de l'est. 1975, est un fabricant professionnel Chinois spécialisé dans les transformateurs de puissance et des réacteurs de plus de 50 ans. Les produits de pointe sont transformateur monophasé, triphasé transformateurs d'isolement, transformateur électrique, transformateur de distribution, l'étape vers le bas et d'intensifier le transformateur de basse tension du transformateur, transformateur à haute tension, contrôle de transformateur toroïdal transformateur, transformateur R-core; inductances DC, AC réacteurs, le filtrage du réacteur, de ligne et de charge du réacteur, des bobines, le filtrage du réacteur, et intermédiaire, à haute fréquence produits.

Nos transformateurs de puissance et les réacteurs sont largement utilisés dans les 10 domaines d'application: transport en commun rapide, les machines de construction, les énergies renouvelables, intelligents de fabrication, des équipements médicaux, de la mine de charbon de l'explosion de la prévention, de l'excitation du système, frittage sous vide(four), d'une climatisation centrale.

En savoir plus sur transformateur de puissance et le réacteur: www.lstransformer.com.

Si vous souhaitez obtenir des solutions personnalisées pour les transformateurs ou des réacteurs, veuillez nous contacter.
WhatsApp：+86 13787095096
E-mail: marketing@hnlsdz.com